If the unkempt garden next door is putting off buyers, rather than suffer in silence, why not simply offer to clear away any rubbish yourself. Next time you're mowing your lawn offer to mow theirs as well. Half an hour spent on a few gardening chores at the neighbour's house could make all the difference when the next buyer arrives to front window repair view your home.
You will next see what is called a parting bead which is a small trim piece about 1/2 inch by 3/4 inch in size partially buried in the window casing. It separates the two sashes. I recommend replacing these and you will find they are very difficult to remove without splintering them. If you are repairing the window and not installing new side tracks you must replace the parting beads. The upper sash and weight removal is the same as the bottom. Don't forget to open the sash pockets at the bottom of the upper sash tracks as well to allow sash weight removals. With sash, weights, nails and pulleys removed, clean all loose paint from remaining surfaces and if your sure it is not lead paint, some sanding may be in order as well.
Check for irregularities. If you're at the car auto glass repair or rear of the car, look along the car to see if there are small dents. These can be seen as distortions in the reflection. If the paint is not smooth in one place, then this could be a place where there has been some damage. Dents as large as a coin can be restored by a panel beater. Dents that are not thoroughly repaired are often filled with polyester resin or fibreglass paste. Tap the surface, or go along it with a magnet. Know whether the panel is made of steel, not plastic, fibreglass or aluminum. If there are places where the magnet will not adhere, then in all likelihood, the panel has been repaired. Ask the owner why the part has been repainted?
Clean up the front yard. Mow the grass. In the winter, shovel the driveway and the sidewalk. In the summer, add some flower pots. Wash the windows windshield chip repair and window screens. Repaint the front steps.
Repeat the process for the opposite side. Set the sash aside making sure you know which is the top and the bottom sash. Place a wood block into the track opening and cut the card knot. The block will help catch the sash weight and allow you to pull it out of the pocket. Remove the pulleys. The pulleys and the weights will no longer be used.
Step 7 - Remove the finishing film after a 10 minute period and make sure the resin had dried completely. Scrape away any excess resin from the surface.